Memory at fe800000 (64-bit, non-prefetchable) Subsystem: Acer Incorporated RTL8111/8168/8411 PCI Express Gigabit Ethernet Controllerįlags: bus master, fast devsel, latency 0, IRQ 35 RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c) Lspci -v shows for the Ethernet controller: 02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready TX packets:257071 errors:0 dropped:0 overruns:0 carrier:0 RX packets:256489 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 Wlan0 Link encap:Ethernet HWaddr 30:10:b3:58:9e:a0
TX packets:2505 errors:0 dropped:0 overruns:0 carrier:0 RX packets:2505 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 Ifconfig -a shows: eth0 Link encap:Ethernet HWaddr f8:0f:41:d7:6e:4c Link/ether f8:0f:41:d7:6e:4c brd ff:ff:ff:ff:ff:ffģ: wlan0: mtu 1500 qdisc mq state UP mode DORMANT group default qlen 1000 Ip link shows: 1: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1 The command cat /etc/network/interfaces shows up: # interfaces(5) file used by ifup(8) and ifdown(8) My setup is by LAN cable to a NETGEAR Powerline extender which is connected to my Virgin Media NETGEAR Superhub. I have tried the same LAN cable and setup on my laptop and it works. Running a diagnostic in Windows shows up as no Ethernet cable connected. The Ethernet connection is also not working in Windows 10.
The option for Ethernet Network is greyed out and only wireless connections are available. After upgrading my dual-boot Windows 10 and Ubuntu 14.04 LTS to 16.04 the wired connection has stopped working.
0 kommentar(er)
